hup! tiled roof

The lightweight hup! Tiled Roof is a available with a choice of full height glazing panels in a range of high performance glass or conventional Velux windows. The roof can accommodate door spans of up to 4m with no need for extra structural support.

Low-Cost Design

- Low cost solution to deliver vaulted and sloped ceilings.

- Supports large spans of doors up to 4m removing the requirement for 
  costly lintels required.

- Full length glazing panels provide a WOW factor and a low-cost way 
  to bring in light.

- Suitable for any roof tiles – traditional slate, concrete tiles, 
   lightweight composite slates or shingles.

Structurally Engineered

- Using a NASA database, the roof is postcode 
  engineered to withstand extreme weather at site six-digit postcode.

- No need for a structural engineer - calculations built into design 
  software.

- Light and strong enough to be used on conservatory refurbishment 
  projects.

Unrivalled Quality

- Pre-fabricated for a high quality finish every time.

- Utilises BBA approved ‘Ultrapanel’ technology.

- Assessed and pre-approved for building control by 
  MFA.

- Independently fire tested.

Site Friendly

- 100% pre-fabricated roof system - no cutting required on site.

- No specialist joinery skills required on site.

- Fast to install – complete structure in as little as ½ day.

- Solar control glass to optimise the solar gain and reduce energy.

- Lightweight panels are cut to size and easy to manoeuvre.

Energy Efficient

- U-Values as low as 0.12W/m2K.

- No cold bridging, fully insulated structural beam.

- Selection of high performance glazing with low U-values.

- Solar control glass to optimise the solar gain and reduce energy.

Building Regulations

As hup! is pre-approved for Building Regulations, this makes compliance extremely fast and simple.

Your hup! builder can choose to work with MFA or a independent Building Control Approved Inspectors. MFA are extremely experienced in every component in a hup! build and can sign off your project with minimal red tape.

Working with these independent Building Control Approved Inspectors for your hup! Building Regulation compliance is a simple alternative to working with your Local Authority.

View approval certificates

Any questions?

Can you put downlighters in the vaulted part of the tiled roof ceiling?

Yes - however you must consider what the room is used for. If there is high humidity, a vapour control layer may be required. This is not provided by Ultraframe and must be placed between the plasterboard and the steel clips.

How are electrics installed with hup! walls?

Cable management panels can be specified beforehand to incorporate a trunking system at 450mm height, allowing the electrician to easily run cables along the wall to the desired locations. If running up the wall, the cable should run in a flexible conduit to separate it from the EPS insulation.

How should I make good the floor if I am knocking down a wall that is wider than a hup! wall on a conservatory conversion?

We would advise using a PVC trim or window board to fill the gap. 

What is the loading of the hup! wall on the base?

0.4 kilonewtons per meter squared.

Is hup! more noisy than brick?

The sound will depend on the claddings chosen and the make up of the brick wall it is being compared with. If finished with render or brick slips, there will be very little difference vs a brick wall as the calcium silicate board does a great job of breaking up the sound.

Still need help?

Contact us today for advice and assistance on growing your business with hup!